Precautions for the use of automatic suction paging machine

The precautions for the use of the automatic suction paging machine are as follows:

1. Equipment debugging:

    1. When using, adjust the guide plates on both sides to a proper distance according to the size of the bag;

    2. When there is ink on the belt of the sorting machine, use alcohol or cleaning fluid to wipe it clean to prevent the ink from affecting the product sensor detection;

    3. The paging machine should avoid idling as much as possible. The wear of the separating toothed belt will be relatively large during idling. Therefore, press the red button to stop the operation in time when there is no paging.

   2. Out of the bag debugging:

     1. When there is a paging card pocket, please pay attention to check: A. Whether the left and right guide plates are adjusted too small; B. Whether the tension spring on the separation press is too tight; C. Whether the bag inlet baffle is not adjusted properly and blocked Board too low

   It will jam the bag; D. Is the pressure roller not adjusted properly; E. Is the bag problematic?

      2. The paging effect is obviously not good. When many bags cannot be separated, pay attention to check: A. Whether the bumps on the separation tooth belt are worn flat, if they are flat, replace the separation tooth belt and press the skin; B. Separate

   Whether the tension spring on the pressing skin is too loose; C. Whether the bag has water or static electricity or other problems; D. The operator has too many bags to page at one time or the operation is incorrect.

      3. There is a deviation when paging, you should pay attention to check; A. Is the guide plate on both sides too small or one side is crooked and not adjusted; B. The sensor position is too low, it will touch the bag; C. The bag is tilted on one side Too

   Stakes should be sorted after being flattened.

      4. Turn off the power switch on the side after stopping the machine every day.

      5. The shell of the sorting machine should be grounded to prevent the influence of static electricity on the operator.

             For more information, please visit Weilai Technology's website: a030.cn